Hello everyone,and welcome to our podcast where we'll be simulating a conversation between Alex and Tom about the setup of the LBCAl160A Beading machine.I'll be reading both parts,so let's get started. Alex:Hey Tom,we've got a plan for the LBCAl160A Beading machine.Since there's plenty of free space next to the existing switch in the machine's electrical cabinet,we're going to start by pulling and terminating the cables at both ends. (pause) Tom:Sounds good,Alex.After we have everything set up on our end,we should connect the cables in the NV automation cabinet.What's the next step after that? (pause) Alex:Once the connections are made in the NV automation cabinet,we'll need to consult with the Wuxi team.They'll help us transfer the patch cables from the current switch,which they supplied,over to the new RJ45 single connectors with the white plastic covers. (pause) Tom:Got it.And what about the other machines?Are we following the same procedure? (pause) Alex:For the other machines,we'll also pull the cables,but we'll wait for the Wuxi team to come back to the site before we start terminating the cables in each machine's electrical cabinet.This way,we can ensure everything is coordinated properly. (pause) Tom:Makes sense.By the way,I heard NV will be providing the power supply to the automation cabinet.Is that correct? (pause) Alex:Yes,that's right.NV will handle the power supply to the automation cabinet.It's all part of the plan to integrate smoothly with the existing systems. (pause) Tom:Alright,let's get started on the LBCAl160A Beading machine then.I'll coordinate with the Wuxi team to make sure they're available when we need them. (pause) Alex:Perfect,thanks,Tom.Let's keep the communication open so we can move forward efficiently. And that's a wrap for our simulated conversation.I hope you enjoyed this播客模拟，and remember to keep communication open in your projects just like Alex and Tom.Take care,and see you next time!